In my Gage Entry -> Standards window and in my Calibration Entry -> Measurements window, there is Standard ID and Gage ID of Standard.

What is the difference between these two items?

If you can think of Standard ID as being the test point or a description of what is being measured and its size. Examples that you might use for Standard ID are as follows:

1. Gage Block .500 Inch

2. Gage Block .750 Inch

Or

1. Pressure Check 25 psig

2. Pressure Check 50 psig

Or

1. Weight 5 grams

2. Weight 10 grams

Or

1. Temperature Check 200 Deg. F.

2. Temperature Check 400 Deg. F.

The Gage ID of Standard positively identifies exactly which particular item was used for each calibration measurement. Examples of Gage ID of Standard might be as follows:

GB-024489-A (Gage Block Set)
DWT-9545458 (Dead Weight Tester)
WT-GR-3374 (Weight Set)
PY-59476-B (Pyrometer)